Instruction to follow for manual eSIM installation
Each device may present slightly different prompts for adding the eSIM profile. Refer to your specific device instructions. After your eSIM is activated, you will receive the eSIM's Activation Code either through your 1PSIM portal or via email. You can proceed with the following manual instructions.
1. Select SIMs and Add a Network:
Start by selecting "SIMs" and then "Add a network."
2. Choose "Download a SIM" and Add a Number Using eSIM:
Opt for "Download a SIM" and proceed to add a number using eSIM.
3. Proceed to "Use a Different Network":
Next, move on to selecting "Use a different network."
4. Download the eSIM profile:
After this selection, your end user is ready to download their eSIM profile.
5. Device Status During eSIM Profile Download:
As the eSIM profile downloads, the device will display this status and may indicate that it could take a few minutes to complete.
6. Prompt to Turn on eSIM in Settings:
Once the download is complete, the end user will be prompted to access Settings to activate the eSIM.
7. Check eSIM Status:
Initially, the end user will observe that their PWG eSIM is currently disabled.
8. Enable eSIM:
To enable their eSIM, they should choose to "Turn it on."
Successful activation of eSIM on an Android device.
Once the eSIM is successfully activated on your Android device, the device will display "Home," indicating successful network connection and full functionality.
